Top tips on stern-to mooring
Mediterranean mooring is usually stern-to and occasionally bows-to
the quay. Boats usually moor stern-to the quay or pontoon for ease of
access ashore; however when unsure of the depth, going bows-to will keep
your drives in deeper water. Alongside berthing is normally only
available at fuel or waiting pontoons.
Stern lines are
used to stay close to the quay or pontoon, whilst either the anchor or a
line from the bow holds the boat away. A passerelle or wooden plank,
carried by the boat, is used to go ashore.
Lazy lines are used in busy harbours and marinas
where multiple anchors would become fouled. Instead of the anchor
holding the bow away, the bow is connected to a heavy bow line, which is
pre-attached to a concrete block on the seabed. The bow line is also
attached to a lighter ‘lazy line’, which is led to the quayside/pontoon.
The lazy line is retrieved from the wall and led to the bow and the
heavier line hauled in and tied off.
- Rig up fenders on either side and at the stern.
- Rig two stern lines - they should be long enough to go ashore and come back to the boat.
- Reverse towards the quay/pontoon.
- Connect windward stern line to quay/pontoon first (i).
- Pick up the lazy line, lead it to the bow and tie off.
- Connect second stern line.
- Adjust bow and stern lines (ii).
(i) To hold the boat in position once the windward stern-line is
attached use small nudges ahead on the leeward engine. If you have a
single engine boat, turn the wheel to windward and use ‘ahead’ to keep
the bow up to wind.
(ii) Often the stern lines are eased
and the bow line is re-tightened, then the stern lines are hauled in
taught. A tight bow line reduces the chance of the stern bashing the
quay or pontoon. Springs which are diagonal lines from either quarter
to the quay can stop the stern moving sideways.
Anchoring - stern-to
- Rig up fenders on both sides and a large fender on the stern.
- Rig a stern line from both quarters.
- Prepare the anchor to drop.
- About four boat lengths away from the quay drop the anchor and ease out chain.
- One boat length from the quay, stop easing the chain so that the anchor digs in. Be ready to ease out more chain if required.
- Connect the windward stern line to shore, followed by the leeward stern line.
- Once positioned the correct distance from the quay, take the strain up
on the chain. To ensure the stern stays away from the quay/pontoon -
often the stern lines are eased and the chain tightened, then the stern
lines made taught again.
In a crosswind it may be necessary to reverse into
wind initially to get steerageway. When slightly upwind of the gap,
drop the anchor and reverse into the space. Ensure the leeward side is
well fendered in case you drift onto the downwind boat.
the wind is on the bow, treat the stern-to mooring as a normal
anchoring exercise. Drop the anchor four-boat lengths out and gently
reverse into the gap with the stern lines ready. One boat length away
from the quay, snub the anchor so that it digs in, then connect the
Written by: Simon Jinks on behalf of the RYA
Pictures: Courtesy of Sarah Selman
Find books for your course at the RYA Shop
Our handy guide shows the books & DVDs that go with your course!